Home » Service Areas » South Jersey » Burlington County » Riverside
A dense grid of twins and rowhomes above the Delaware. Shared walls and flat rear additions decide how a Riverside roof gets built.
Riverside sits on a compact grid between the Delaware River and the Rancocas, and most of it went up while the watch case works and the mills were running. The stock is twins, rows and narrow singles on small lots. Front slopes are steep and short. Behind them, kitchen and porch additions run nearly flat, often right up against the neighbor’s wall.
On a house like that the roof is really two systems. We run architectural shingle on the pitched section and a single-ply membrane on the low-slope rear, then treat the party wall and its flashing as the detail that matters most. Permits are filed with the Riverside Township construction office under the New Jersey Uniform Construction Code.
The full Maze Roofing range, residential and commercial, from the local team.
Shingle, tile, metal and flat roofing for homes and townhomes across the area.
Shingle, tile, metal, flat and TPO. Managed from tear-off to cleanup.
Flat, TPO and metal systems, with maintenance programs that protect the asset.
Storm damage, active leaks and fallen trees, with 24/7 phone response.
A pitched front and a nearly flat back join at a wall or a step, and that single transition has to take water off both planes at once.
EPDM or TPO on flat kitchen and porch additions where shingle cannot shed properly.
Counterflashing set into the shared wall so runoff stays out of both houses.
Staging, dumpster placement and cleanup planned for narrow streets and small yards.
The Riverside Township construction office issues the roof permit and sends the inspector.
Same office, same crews, a short drive away.
Yes, and it is done all the time here. The work stops at the party wall, and new counterflashing and a proper termination go in at that line. We let your neighbor know the dates so nothing surprises them, and we photograph the wall detail when it is finished.
No. Shingle needs pitch to shed, and on a near-flat deck it holds water at the laps. A single-ply membrane such as EPDM or TPO, seamed and flashed up the wall, is the right system there. It can be done at the same time as the pitched section.
Yes. The Riverside Township construction office handles roofing permits under the New Jersey Uniform Construction Code. We pull it under our New Jersey HIC registration and handle the inspection. On a twin, only your half of the structure is on the application.
Usually in the driveway or one curb space directly in front, with boards down to protect the surface. On the tightest blocks we use a smaller container and haul more than once. We walk the street with you before the start date so the plan is settled in advance.
Send the form and the correct local office follows up, or call your market directly.
Fill out the form and we’ll route it to the right person and location.