Licensed & Insured · Serving South Florida & Tampa Bay
South Florida: (754) 258-4590 · Tampa Bay: (813) 694-8151
Decades of protection, high wind resistance and a clean modern profile. Engineered and installed for coastal and inland Florida properties.
Metal roofing uses interlocking panels or metal shingles over a sealed underlayment to create a continuous, weather-tight surface. It’s one of the longest-lasting systems available, and one of the best suited to Florida’s heat, sun and storms.
From standing seam to metal tile profiles, we spec and install systems engineered for high winds, driving rain and decades of UV exposure.
40–70 years of service, often two to three times the life of asphalt shingles.
Interlocking panels rated for the high winds of Florida’s hurricane season.
Reflective finishes cut heat gain and can lower cooling costs in summer.
No granule loss and minimal upkeep. Occasional inspections keep it performing.
Non-combustible Class A materials for added protection.
Clean lines and a range of profiles and finishes that lift property value.
Concealed-fastener panels with raised vertical seams, the premium, weather-tight profile.
The durability of metal in a profile that mimics shingle or tile looks.
Exposed-fastener panels, a cost-effective, proven Florida classic.
Homeowners who want a roof that lasts decades, stands up to storms and lifts curb appeal.
Businesses and property managers looking for durability, low upkeep and a long service life.
Metal is one of the best-performing systems for Florida, but only when it’s specified and fastened for local conditions. That’s what we do.
Wind-rated panels and fastening for HVHZ requirements.
Sealed seams shed water fast, even in heavy storms.
Reflective coatings resist fade and cut attic heat.
Corrosion-resistant alloys and coatings for the coast.
We assess the deck, pitch and details, and take precise measurements.
Choose the profile, color and finish; we confirm the code-compliant spec.
Old roof removed, deck repaired as needed, high-temp underlayment installed.
Panels set, seamed and fastened to manufacturer and wind-load spec.
Trim and flashing finished, final inspection, magnetic nail sweep.
Periodic inspections of fasteners, sealant and flashing keep the warranty valid and the roof performing for its full life.
A few honest points so you know what to expect.
Metal costs more than shingles initially, but its lifespan often makes it cheaper over time. Financing is available.
With proper underlayment and decking, a modern metal roof is no louder than other systems.
Metal’s performance depends on correct fastening and detailing. This is not a system for inexperienced crews.
Same system, same standard. Call the office that covers your property.
Fort Lauderdale · Broward County · Miami-Dade · Palm Beach County
Tampa · Riverview · Brandon · Valrico · St. Petersburg
Flexible options to fit a long-term investment into your budget.
Manufacturer material warranties, backed by our installation warranty.
Documented reports to support storm-related claims.
Most metal roofs last 40–70 years depending on the system and finish, often two to three times the life of asphalt shingles, even in Florida’s harsh sun and storms.
Yes. Properly installed metal systems are among the most wind-resistant available, with panels and fastening rated for high-velocity hurricane-zone wind loads.
Not with a modern install. Solid decking and quality underlayment mean a metal roof is no louder than shingle or tile in heavy rain.
Reflective and cool-roof-rated finishes reflect solar heat and can reduce attic temperatures and summer cooling costs.
The upfront cost is higher, but the much longer lifespan and lower maintenance often make metal more economical over time. Financing is available.
In some cases, yes, but we usually recommend a tear-off to inspect the deck and install fresh underlayment. We’ll advise based on your roof’s condition.
Send the form and the correct local office follows up, or call your market directly.
Fill out the form and we’ll route it to the right person and location.
