Licensed & Insured · Serving Florida, Pennsylvania & New Jersey
Greater Philadelphia: (267) 692-2511
Essington and Lester sit low and open between the Delaware River and the marsh. Roofing specified for real wind exposure.
Tinicum Township is river ground. The Delaware forms its southern edge, Darby Creek wraps the northwest side past the John Heinz refuge marsh, and Philadelphia International Airport occupies much of the middle. The houses are concentrated in Essington and Lester, sitting low and open with very little between them and the wind that comes up the river.
Exposure changes the specification. Starter courses, nailing pattern, ridge and hip treatment and edge metal all get built for wind rather than for a sheltered inland street. We also look closely at how water leaves a low roof here. Roofing permits are issued by Tinicum Township under the PA Uniform Construction Code.
The full Maze Roofing range, residential and commercial, from the local team.
Shingle, tile, metal and flat roofing for homes and townhomes across the area.
Shingle, tile, metal, flat and TPO. Managed from tear-off to cleanup.
Flat, TPO and metal systems, with maintenance programs that protect the asset.
Storm damage, active leaks and fallen trees, with 24/7 phone response.
On open river ground a nor’easter finds the rake, the ridge and the first course, which is where roofs in Essington and Lester usually start letting go.
Higher fastener counts and correct placement on exposed slopes and at the perimeter.
Edges and ridge caps secured where gusts try to peel the first course.
Flat porch and addition roofs given membrane rather than shingle near the water.
Essington and Lester addresses are permitted by Tinicum Township under the state code.
Same office, same crews, a short drive away.
Essington · Lester · Smithtown · Larchmont · Durham Village · Westinghouse Village
Tinicum Township. Essington and Lester are unincorporated communities within the township, so they have no separate permit office of their own, and the township administers the Pennsylvania Uniform Construction Code for both. We file the application and meet the inspector as part of the work.
Rakes, ridges and eaves are where wind gets underneath, and on exposed ground those edges take the worst of it every storm. Usually the cause is fastening at the spec minimum, a missing starter strip, or edge metal that was never secured properly. Fixing the detail stops the pattern.
Not in a way that changes the roofing system. What does matter here is exposure: open ground, wind off the river and damp air that is harder on metal components than on shingles. We specify flashing, fasteners and vents with that in mind.
We prioritize active leaks and we will tell you honestly where you sit in the queue rather than promising a time we cannot hold. A temporary cover is a stopgap, not a repair, and we follow it with a proper inspection once the weather allows. Call the Wayne office and we will schedule it.
Send the form and the correct local office follows up, or call your market directly.
Fill out the form and we’ll route it to the right person and location.
