Licensed & Insured · Serving Florida, Pennsylvania & New Jersey
Greater Philadelphia: (267) 692-2511
Across the Schuylkill from Pottstown, but inside East Coventry Township. Roof replacement for older borough-scale housing and the streets behind Route 724.
South Pottstown carries a Pottstown mailing address and sits just across the Schuylkill from the borough, but it is part of East Coventry Township in Chester County. The housing reflects that closeness: tight lots, older frame and brick houses of borough scale, plus newer construction on the roads running back from Route 724. Many of these roofs have already been replaced once.
A second replacement is a different job from a first one. We look at what the last crew left: layer count, nailing patterns, flashing that was reused, ventilation that was never added. Then we build back properly. The permit for a South Pottstown address is issued by East Coventry Township, not by Pottstown and not by the county.
The full Maze Roofing range, residential and commercial, from the local team.
Shingle, tile, metal and flat roofing for homes and townhomes across the area.
Shingle, tile, metal, flat and TPO. Managed from tear-off to cleanup.
Flat, TPO and metal systems, with maintenance programs that protect the asset.
Storm damage, active leaks and fallen trees, with 24/7 phone response.
On a house that has been re-roofed before, the leak is usually at a chimney, sidewall or vent where old metal was left in place.
Two or three old layers change the tear-off, the deck condition and the plan.
Brick chimneys on these older houses need new step and counter flashing, not caulk.
Narrow side yards mean protection for siding, windows and plantings next door.
East Coventry Township issues the permit for South Pottstown addresses, despite the Pottstown mail.
Same office, same crews, a short drive away.
East Coventry Township, if you are in South Pottstown. The mailing address belongs to the Pottstown post office, but the municipality is East Coventry, and it is the township that administers the Pennsylvania Uniform Construction Code for your property. We file there and handle the inspection.
It is the single most common source of leaks we find on a second-generation roof. Step flashing has to be woven into the new shingle courses and tied to counter flashing cut into the brick. Reusing old metal saves a couple of hours and costs you a ceiling.
Yes, that is normal here. We set up protection against the neighboring wall, stage material on the accessible side, and drop debris into a contained chute rather than the side yard. Tight sites take a little longer, so we build that into the schedule instead of rushing the cleanup.
Framing on older houses is usually adequate for local snow load, and the real risk is not weight but ice damming at the eaves. Meltwater backs up under shingles that have no membrane beneath them. We add ice-and-water underlayment at the eaves and valleys on every replacement.
Send the form and the correct local office follows up, or call your market directly.
Fill out the form and we’ll route it to the right person and location.
